NEWS

News Center

Picture Name

Shanghai Shang Shaft Bearing Quality Inspection Institute Co., Ltd.

Picture Name

Address: 301 Shangxue Road, Jiading District, Shanghai

[Rising Knowledge] How is the ball in the bearing installed?

2020-04-23 14:14

In the bearing industry, The process of placing the steel balls in the middle of the inner and outer rings is called "closing". 

"Fit" process:

1. Prepare the inner and outer rings and place the inner rings on one side.

2. Put in the steel ball

3. Divider the ball, use the ball divider with small claws to evenly separate the steel balls

4. Position the holder and rivet the two pieces of holder and

In actual production, there are also full-loaded ones, usually with ball loading gaps. Less used: it can be seen that there is a ball loading gap on one side, and the steel ball is filled in from that gap, but this kind of bearing has a relatively small ability to bear axial load and is less used.

This article is taken from the bearing industry magazine, if there is any violation, please contact delete.